@selena wrote:
Hi, I am experiencing issues with the grey resin on the form 2. I recently received the new V3 and first issue was the resin would not dispense. I realised that this was because the bottom opening was not properly pierced. I fixed this issue and the first print was successful. The second print was a complete failure. The resin needed to be completely strained, except resin is too thick to make it through the strainer. So to make sure that I have a clean start, I decided to try again with all fresh resin.
The issue is now that the resin is having problems dispensing again. I checked the rubber release and that is totally clear, but every time it tries to dispense anything, the screen flashes with a 'cartridge missing' immediately followed by a 'cartridge inserted' inserted alert. Then tells me to check that the top is open (I completely removed the top at the start of the print).
This has been going on for about half an hour and the tank does not even have enough resin to cover the base. Any suggestions? Does this constitute a support ticket?
Posts: 2
Participants: 2