@Sstage wrote:
Using my Form2 to create functional, 1 off motor mounts, landing gear fixtures, and sensor mounts for an vtol drone running arduplane on a pixhawk. I'm currently fighting with material failures as my yield strength with tough appears to be closer to 20 MPa than the advertised 55 MPa. The next print will have 3k carbon fiber epoxied to the failure points.https://drive.google.com/open?id=0B9egjsa9aEXWVXZWM09NaVhkUlU
https://drive.google.com/open?id=0B9egjsa9aEXWaWlCVk9Tdl93SDg
Posts: 12
Participants: 4