@KBS756 wrote:
Has anyone tried using B9 Yellow Resin on the Form2? It gives me phenomenal results on my Solus printer, significantly more consistent than the results that I get with Castable V2 on my Form2.
If so does anyone know the ideal settings for it, I know that it isn't officially supported but was wondering if anyone had any experience making it work. For example I've in the past successfully printed Makerjuice Waxcast on the Form2 using Castable V1 25 Micron settings, and on the Solus its about 51.5% the exposure time of the B9 Yellow on Solus
I expect that it should be possible to work on a Form2 because its mechanism is very similar to the B9 with its slide
I remember reading before that placing an item over itself in Preform results in double exposure of the item is this still how it operates? Example I place the same item over itself in preform to get it to double expose the settings that work for Waxcast since preform has yet to allow for custom exposure times.
Asking mostly because Yellow gives me more consistent printing and casting results from the other printer, while Formlabs Castable V2 seems to work some times and other times smaller holes get filled in or prongs close to each other fuse, which did not seem to happen for Castable V1 and doesn't happen for B9 Yellow.
Thanks for any help
Posts: 2
Participants: 2