@David_Persuhn wrote:
After a job prints, it would be nice if the estimated print time that is shown on the machine could be updated to use the actual print time. This way, re-running a job from the machine would show a more accurate time estimate, which I have found can vary pretty dramatically on long prints.
I just finished a job where the estimate was off by several hours (took about 25% longer than estimated) Since I know it will be used again at some point, but likely not for a while, having the information stored right in the job would be far more handy than having to look it up in dashboard history or an external log book.
Posts: 2
Participants: 2