@Djmars wrote:
Hi all,
About to order form 2 and have a couple of questions see if anyone else had tried.So first up imagine a bat wing with small hollow channels where bones would be, pockets inside the flexible resin. Printed with drain hole and flush clean with syringe IPA, could you then inject tough into these pockets and use UV postcure box to harden them?
Second question, has anyone printed a clear resin object and then cast that object inside clear polyester resin so it's floating in the middle? Thinking with the finish at 100micron if you illuminated from bottom the printed part would light up quite nicely?
Much appreciated any opinions.
Looking forward to trying printer out, mainly medical engineering but knowing different ways to apply the tech always adds value.
Posts: 2
Participants: 2