Form Failed print 2 only supports being printed?

@ArchonStudio wrote:

Ok, so a brand new printer.
Symptoms: Ran a long 3d print, that ended up with some missing details.
After setting up the same elements, the printer only printed supports, there was nothing in the resin tank (failed print leftovers).
Set it up again, cleaned resin tank, “leftover resin” was no used, ujust fresh one, and the same effect.
On the printer screen you can see the STL with support so I would assume that file was imported correctly?
Anyone has the same issue?

Thanks

Posts: 3

Participants: 3

Read full topic