@Rhodes69 wrote:
Just bought a Form2 last week, had good luck on two small 3 hour prints. The third print was 6 hours and I it was CRAP!! What is up with the Grey V4 resin? I have firmware rc-1.16.8-19 and Preform 2.15.1 loaded. The time between the last prints was at least 12 hours. There was still some bubbles visible in the resin. After the 6 hour print, I had so many bubbles in the tank and on part, I couldn’t believe it. After 10 mins in Form Wash I was pissed!!
I have seen other posts about this problem, but no Form Labs solution.
The people that have had this problem, what did you do to solve it??Chris
Posts: 1
Participants: 1