Advice on print?

@MASSCollective wrote:

I am about to begin printing this model (see attached photos) and it will be my longest (24 hours) and largest (4"x4"x5") print yet. It will be in Clear V4, brand new tank and cartridge, any advice before printing to ensure it is successful? One side also has a 2" hole through it.

I’ve had problems in the past with models oriented perpendicular to the print bed but this really has no other choice.

Screen Shot 2018-03-16 at 1.59.23 PM.jpg1738x1446 498 KB

Screen Shot 2018-03-16 at 1.59.31 PM.jpg1524x1324 541 KB

Posts: 8

Participants: 4

Read full topic