@Ken_Weiland wrote:
I've had my Form 2 for about 5 months and using almost every day with great success on my projects, but what I need help with is editing those supports. Many times I let the software generate the supports automatically, but a lot of times the connection points land in areas that are difficult to reach and finish. So I go into the edit mode and move the points, sometimes only a fraction of an inch and then the parts fail. I also check very carefully as I move each point if the area shows any red color as a warning, and if it does, I either shift the point or even add an extra one. But when everything looks good, no red areas and I print the model, sections either don't print or they drop into the tray.
Are there any rules to follow to ensure that moving the points won't ruin my print?
Posts: 4
Participants: 4