Angled gap between platform and tank

@MattiaMercante wrote:

Hello,
from some months my Form1+ is affected by a strange problem: the plane of the building plane isn't parallel to the bottom of the resin tank. When prints starts I can see a small gap in the right side of the building plane. The contact is fine along the left one, in the side where is the hinge. But gap increase progressively moving to the right side.
Maybe the resin tank isn't well aligned? Maybe it lost some "steps" along the screw that let the tank be tilted?

There is a way to send commands to machine to screw it some steps and make the parallelism correct again?

Thanks in advance for the kind replies,
Mattia

Posts: 1

Participants: 1

Read full topic