@Komy wrote:
I just got Form 2 printer, had no time to waste so I started to print small key chain. At the beginning there was error with some sensor problem, on forum and support I found out that I need to clear sensor, or I put try too strong inside... Solution, put out resin tank, clear sensor and get back and start again, but problem was that my wiper was on right and it was not possible to put out resin tank. I found solution on second post helped me "you've inserted the tank into the tank bed too sgressively" So i was putting tank too strong inside and too close to sensor obviously. Now it is printing everything is fine but have million questions about what to do next. After print scrape this model from build platform, put it 10 minutes in 99,9% IPA then in second tank with IPA too? I don't have UV lamp at the moment is it good to clean it with water and left it to get harder? Also how do I clear build platform?
Second question is how to clear resin tank? and what to do with resin in tank? left it for next print ? I have white resin by the way.
Health? I can smell this resin, is it healthy to breath it? printer is 15 cm from my working monitor. I was thinking to make glass hermetic box with ventilation to outside?
IPA is it dangerous? What is best solution for you after print? what are yours experiences ?
Thanks in advance
Posts: 2
Participants: 2