@industrialforms wrote:
Dear all I have currently Form 2 machine and have project where I am trying to design part with superior detail.
I tried to use grey, but this material is too brittle and doesn't define details well enough.Time ago subcontracted job on Envisiontec machine and this parts are just superior !!! I used photosilver RCP130.
Parts been very precise, accurate, strong almost like injection molding parts I loved them.They been very expensive too....
I was thinking about buying Photosilver RCP130 from envisiontec - cost £345 per kilo and trying on Formlabs.
What do you guys think about success of project like that ?
Did anybody tried to do experiment like this ?Below you will find link to RCP130datasheet:
Best Regards
Robert Plauszewski
Posts: 1
Participants: 1