Optimizing prints:

@David_Boydston wrote:

Hi Guys,
I just got my printer this monday, I've been playing around with various settings trying to learn how to optimize my prints, just as an FYI if you havent learned some lessons:
- Print at least 2mm of base layer, i tried to print the lowest possible to "save material" however the thing was impossible to scrape off the build platform, took me a few hours to clear all of the littler chunks it kept breaking into.

Now, for my question:
How do you play around with the Base of the build?
I have a part that's basically a ring-ish piece, hwoever the blob occupies the whole space inside, I think THATs a waste of materal:

image.jpg898x569 86 KB

Posts: 7

Participants: 7

Read full topic