@campingtomz wrote:
So i was looking for a cheaper Resin for my form1+. since 150 per litter is out of my budget.
so i picked up a litter of the black and 1/2 litter of the red from maker juice. this stuff sucks. its very inconstant and not only that i haven't had a successful print with it. the prints come out but they are deformed or just shit.
im not sure if i am doing something wrong here. im just frustrated at this now. i really want to get this working but it seems i am not ment to get this form 1+ working
http://imgur.com/Bok8lBl the deformed side is the support sidehttp://imgur.com/EZn4ZCx - did not even finish just like it stopped printing part of it
http://imgur.com/OvoaDSY - thought i had figured it out but it bends to the base..(away from supports)
http://imgur.com/kwIbAIM my two attempts. one to the right(top) is hallow the deformed side is again the support side
Printer info
FormLaps From1+
settings:
layer thickness: .1
material: black, V2 FLGPBK02) using the Formlabs settings figuring that should work the best.
support settings:
density: 1
Point-size: .6mm
Slope multiplier
base thickness: 2mm
height above base: 5mm
Posts: 7
Participants: 3