@Schoner wrote:
Hello,
I'm searching for a rubber-like material for a while and tested the Formlabs flexible resin and others. Unfortunately nothing matched my requirements so far.
Now I did a try on Photocentric's Flexible UV.
The result is looking promising at a first glance.But see what happend after a few hours:
As you can see, the silicone layer has detached off the tray.
Has anyone seen a problem like this before?
I'm not sure, is it the resin liable to this issue or did i get a deficient (new) tray?Best regards
Juergen
Posts: 4
Participants: 3