@ID_Guy wrote:
So after 17 prints I get the low cartridge warning which is expected. If I add up all the jobs I have used around 535.44ml of the 1L tank. Sure there was some additional loss due to build platform and resin clinging to part, filtering of resin etc.
The question I have is the low tank graphic accurate? Do I have just under about 25% left in the tank or is that a generic low tank graphic that never changes? The reason I ask is I need to run another 56ml job tonight, but don't want it to cut out halfway through since I dont have another clear resin cartridge on hand? If the job pauses to tell me the cartridge is empty can I have it continue if I know there is enough in the tank to finish it? The tank holds 260ml so it should be enough to finish the job just with what is in the full tank. Its a little unclear what to do when you need to run more jobs on a tank that is running low. It would be nice the software could estimate ahead of time that you may not have enough in the cartridge to finish the job.
Posts: 3
Participants: 2