@Zenica wrote:
I ran out of grey, my go to color and had to use the black I have.
Back when I bought a supply of resin cartridges I bought three black, four grey and one clear.
The grey and clear are good, no real issues with the resin.The black on the other hand is pure garbage. Most every time I use it, the print fails. The supports are always so weak, sickly almost. I can break them off with a stern look. They bend and flex as if they didn’t cure.
The same file, same supports and print settings in grey or clear does not have this issue. I printed a file as per a suggestion from Danke but as you can see, that print failed miserably wasting about 8 hours of time. Thanks Danke.
The same file at .25 at least printed but had globs of semi cured resin on it and the printed objects “skin” was peeling off. Post curing saved some if it.
For those of you that use black, are you doing something in the settings to get better results?
Posts: 2
Participants: 2