@udesigns wrote:
Form 2 purchased in Dec 2016, did not get much use of it during 2017, just some small prints here and there. Have not even finished the first resin cartridge.
Yesterday I was curious enough to go back to the office after hours to see how the 6-hour print goes and found leaked resin along the base of the tank and the build platform was empty. I immediately stop the print and removed the tank and found the entire bottom acrylic fell off and the resin seeps under the silicone layer, which was not glued to anything whatsoever.
Formlabs should recall this tank. If I didn’t happen to go back to office, our printer will be gone. Be careful guys!
Posts: 2
Participants: 2