@sharpknlfe wrote:
My stepper motor was jammed in the tilt posistion, i managed to un jam it by taking the one screw out on the top where the rod and peice meet , and lifting it back. . My question is now it wont tilt, I am pretty sure I reseated the stepper motor screw in the wrong place, also when trying to unjam I turned the rod a good while so that probably also broke it. The motor turns but the tray doesnt tilt.
I am thinking I need to readjust the screw on the top of the rod/ my stepper motor rod is in the wrong place. what is the best way to do this. It is a form 1 by the way.
I know people have replaced the motor but where does the rod need to be and the screw that holds it?.
Thanks,.
Posts: 1
Participants: 1