@LuxonEng wrote:
I’m an engineer, I get it. Sensors are nice and useful. It’s a good way to keep the wrong material from mixing in the wrong tray. Or the wrong material from being used on the wrong print job. But what happens when the sensors break? The Form 2 becomes absolutely useless.
Why isn’t there an override? I know that the tank is installed correctly. I know that the material matches. I know that everything is as it should be. But because the sensor only works intermittently, the machine becomes useless. And worse, it starts to work as it should, but then decides that the cartridge is no longer installed mid-print wasting time and money. And pissing off my customer in the process.
What can fix this? An override. A simple, “are you sure you want to proceed” or a manual selection of what material is installed. An advanced “I’m actually smarter than the machine” mode is what we need. Why doesn’t this exist? And I’m not talking about Open Mode. I purchased the Formlabs materials, I want it to work with the advantages of the machining knowing those materials.
Posts: 1
Participants: 1