@Walter_Gillespie wrote:
I’m experiencing what I feel is a heavy loss of parts due to the supports being placed too close to the piece being printed. This has been brought up before but nothing seems to have been done about it in Preform.
a 20% loss, 8 out of 40 piece on one build plate all duplicates of the same item is not good. The parts are useless and have to be discarded. It’s not only a loss of time but also of resin.
Preform should space the supports away from the parts being printed or allow for a variable to do this minimum spacing.
No, I don’t feel I should have to go in and manually create supports to offset a software issue with Preform. This is a basic need of the software to ensure that the supports don’t interfere with any piece being printed.
Posts: 7
Participants: 3