@timw wrote:
I’m working on a project using the high-temp resin. The part is a little heat-sink and I’ve been prototyping it on and off for the last month. It had been printing fine (dozens of times), and then suddenly in the last couple of days the gaps between the “fins” have been clogged with solid resin after printing, and the holes are too small. The picture below is the “transition” part - the right side is clog-free but the left is clogged. After this, all new parts have been clogged.
I’m going to try tweaking the x/y scaling on the printer since the part appear to be about 2% too small now, but I wondered if anyone had any other ideas? The same resin and tank were used for all test, and I’ve made sure to use fresh areas of the tank. If it is scaling, why would that suddenly have changed? This is brand new machine (just recently replaced for a faulty one).
Posts: 1
Participants: 1