@ribbons wrote:
HI,
This will probably be a few simple questions, and I'm being over cautious, however....I take it if I am printing back to back, as long as the print worked, I can just remove the print from the build platform and set off a new print using the existing resin in the tray? The Form 2 wont attempt to add more resin for the next print and overfill the tank?
Do I pour away any remaining resin left in the resin tray if I have finished printing? Or can it be left in there for a few days before I start printing again?
As an observation, I found the higher detail print at 0.025 was actually worse compared to 0.05. Is this common?
Thanks in advance and sorry for the novice questions
Keith
Posts: 3
Participants: 2